NASLite Network Attached Storage

Whats the secret to mounting a Drive. I've formatted the drive, ran the file system check, did the check and repair, every thing reports good. I rebooted after the format, and several time since, but can't get the drive to mount. other drive on the same controller mount fine. just not the new drive. I ran into this with the first drive I tried to mount, I did the same thing and it eventually worked. But I can't seem to get this one to.any ideas?

Hex

Check the disk configuration and make sure it's set to RW or RO

Example :

DISK-1 CONFIGURATION MENU

Disk Model: MegaRAID LD 0 RAID5 1430G, v.713N
Interface: SCSI, HOST-1, BUS-0, TARGET-0, LUN-0
Status: DISK IS MOUNTED!
Usage: 1.3T / 548.0G / 827.4G / 40% - ( Size / Used / Free / Used% )

1 - Export Disk-1 [ RW ] (RW, RO, --)

after a few reboots and messing with it, it mounted. I'm not sure what the fix was. no biggie, it mounts every time now.

thanks

1 - Export Disk-1 [ -- ] (RW, RO, --)

Above is the default, unless it's changed to RW the drive won't mount, sounds like you took care of it.